INSTALLATION
WARNING:
Inspect the Oven:
•Check the oven carefully for damage before and regularly after installation.
•Make sure the door closes properly, that it is not misaligned or warped.
•Check the hinges and door safety latches are not broken or loose.
•Ensure the door seal and sealing surfaces are not damaged. If the door or door seals are damaged, the oven must not be operated until it has been repaired by a competent person.
•Inspect the oven interior and door for dents.
IMPORTANT:
If any damage is apparent, do not operate the oven in any way, until it has been repaired by a SHARP trained engineer.
1.Remove all packing materials including the feature sticker (if applicable). Do not remove the plastic film from the inside of the oven window as this protects it from dirt. The waveguide cover prevents food and grease from entering the waveguide area where it could cause damage. DO NOT REMOVE THE WAVEGUIDE COVER.
2.Place oven on a secure, level surface. Ensure it is strong enough to take the oven weight, plus the heaviest item likely to be cooked in the oven.
3. The minimum | 15cm |
height of free space | |
necessary above |
|
the top surface of |
|
the oven is 15cm. |
|
4.Do not place the oven where heat, moisture or high humidity are generated, (for example, near or above a conventional oven) or near combustible materials (for example, curtains). Do not block or obstruct air vent openings. Do not place objects on top of the oven.
5.Make sure the power supply cord is undamaged (See “ELECTRICAL CONNECTION” below).
Do not allow the power supply cord to run over any hot or sharp surfaces, such as the hot air vent area at the top rear of the oven.
6.The socket must be readily accessible so that it can be easily unplugged in an emergency.
7.Do not use the oven outdoors.
BUILDING-IN-KIT.
No
This oven is designed to be used on a countertop only.
ELECTRICAL CONNECTION.
•Do not allow water to come into contact with the power supply cord or plug.
•Insert the plug properly into the socket.
•Do not connect other appliances to the same socket using an adaptor plug.
•If the power supply cord is damaged, it must be replaced by a Sharp approved service facility or a similarly qualified person to avoid a hazard.
•When removing the plug from the socket always grip the plug, never the cord as this may damage the power supply cord and the connections inside the plug.
•If the plug fitted to your oven is a rewireable type and in the event of the socket outlet in your home not being compatible with the plug supplied, remove the plug properly (do not cut off).
•If the plug fitted to your oven is a non- rewirable type and in the event of the socket outlet in your home not being compatible with the plug supplied,
•Refit with a suitable type, observing the wiring code given in `To replace the mains plug’ on page 38.
4
