C L E A N I N G A N D C A R E
Disconnect the power cord before cleaning or leave the door open to inactivate the oven during cleaning.
Before cleaning ensure that the oven cavity is cool.
DO NOT USE any abrasive or harsh cleaners or metal scouring pads that will damage or dull the stainless steel.
Exterior
The outside surface may be cleaned with mild soap and water; wipe with a soft cloth. Do not use any type of household or abrasive cleaner that will damage or dull the stainless steel.
Door
Wipe the window on both sides with a damp cloth to remove any spills or spatters. Metal parts will be easier to maintain if wiped frequently with a damp cloth. Avoid the use of spray and other harsh cleaners as they may stain, streak or dull the door surface.
Touch Control Panel
Wipe the panel with a cloth dampened slightly with water only. Dry with a soft cloth. Do not scrub or use any sort of chemical cleaners. Close door and touch
STOP/CLEAR.
Interior
For easy cleaning, wipe any spatters or spills with a soft damp cloth or sponge immediately after use or at the end of each day. The oven is easier to clean immediately after use.
For light spills, heat 2 cups of water in a
Do not use any abrasive, harsh or corrosive chemical cleaners. For heavy spills, use only cleaners recommended for stainless steel. Always put the cleaner on a soft cloth and rub on the soiled surface, being careful that none of the cleaner gets into any of openings in the walls or the ceiling of the cavity. Wipe clean with damp soft cloth. Polish dry.
After cleaning the interior thoroughly, residual grease may be removed from the interior ducts and heaters by simply operating the oven with Refresh Cycle on page 26. Ventilate the room if necessary.
Caution:
Make sure that mild soap or water does not seep through the small vents in the walls, because it may cause damage to the oven. Never spray directly onto the oven walls. Spray onto a soft cloth and wipe.
Waveguide Cover
The waveguide cover is made from mica so requires special care. Keep the waveguide cover clean to as- sure good oven performance. Carefully wipe with a damp cloth any food spatters from the surface of the cover immediately after they occur.
Accessories
The turntable, turntable support and racks can be re- moved for easy cleaning. Wash them in mild, sudsy water; for stubborn stains use a mild cleanser and a
Foods with high acidity, such as tomatoes or lemons, may cause the porcelain enamel turntable to discolor. Do not cook highly acidic foods directly on the turn- table; if spills occur, wipe up immediately.
SPECIAL NOTE for TURNTABLE SUPPORT
After cooking, always clean the turntable support, es- pecially around the rollers. They must be food and grease free.
roller
Crumb tray
Wipe the crumb tray with a soft damp cloth after use or at the end of each day.
Crumb tray
SERVICE MAINTENANCE CLEANING (not covered under warranty)
It is recommended to schedule maintenance cleaning for Exhaust Duct, Convection Fan Unit, Top Heater Unit and Side Heater Unit by authorized servicer ev- ery 12 months or more often if heavy grease laden foods are cooked very frequently. Contact your near- est SHARP AUTHORIZED SERVICER.
Oven Light Replacement
1.To replace the light bulb, first disconnnect power cord.
2.To release cover remove the screw on the oven light access cover. (See OVEN PARTS on page 9.)
3.Replace light bulb with a new one, 240V, 25 W bulb.
4.Replace the oven light access cover and secure with the screw removed in step 2.
29
