INSTALLATION
WARNING
■Do not install the refrigerator in a damp or wet location as this may cause damage to the insulation and a leakage . Condensation may also build on the outer cabinet and cause rust .
1Keep adequate ventilation space around the refrigerator.
•The figure shows the minimum required space for installing the refrigerator. The measurement condition of power consumption is conducted under a different space dimension.
•By keeping greater space, the refrigerator may be operated under a less amount of power consumption.
•If using the refrigerator in the smaller space dimension than the below figure, it may cause the temperature rise in the unit, loud noise and failure.
3 Remove the 2 screws of the cabinet lower part, and then set the foot cover (supplied inside the refrigerator compartment) with removed 2 screws.
| Foot cover |
NOTE | Screw (2 screw) |
|
•Position your refrigerator so that the plug is accessible.
•Keep your refrigerator out of direct sunlight.
•Do not place next to heat generating appliance.
•Do not place directly on the ground. Provide suitable stand.
When transporting
90 mm or more
60mm or more
b
60mm or more
a
| ||
| ||
a | 1110mm | 1103mm |
b | 1330mm | 1330mm |
•The casters allow the refrigerator to move back and forth.
•Carry the refrigerator by holding the handles located on the rear and the bottom.
Free standing type
2 Use the two front adjustable feet, to ensure that the refrigerator is positioned firmly and flat on the floor.
rear bottom Caster
Before using your refrigerator
Clean the inside parts with a cloth soaked in warm water. If soapy water is used, wipe it off thoroughly with water.
INDICATOR OF TEMPERATURE
This refrigerator is provided with an indicator of temperature in the refrigerator compartment to allow you to control the average temperature in the coldest zone.
Coldest zone
Symbol
BLUEWHITE
The symbol indicates the coldest zone in the refrigerator compartment.
(The door pocket positioned at the same height isn't the coldest zone.)
Checking the temperature in the coldest zone
You can carry out regular checks to ensure the temperature in the coldest zone is correct and, if necessary, adjust the refrigerator temp. control.
To maintain a correct temperature inside the appliance, check that the indicator of temperature is always BLUE.
If the indicator of temperature turns WHITE, the temperature is too high; in this case, increase the refrigerator temp. control setting and wait for 6 hours before checking the indicator of temperature again.
Correct setting Temperature too high, adjust the refrigerator temp. control.
NOTE
•The internal temperature of the refrigerator depends on various factors such as the ambient temperature of the room, the amount of food stored and the frequency of door opening.
•When fresh food has been introduced or the door has been left open for some time, it is normal for the indicator of temperature to turn WHITE.
5