Sharp TINSE1166MPZZ operation manual Preparing the Remote Control Unit, Connecting the Power Cord

Preparing the Remote Control Unit

Installing the batteries

1.Press the cover gently and slide it in the direction of the arrow.

2.See the instructions in the compartment and put in the batteries (R-6 (“AA” size) x 2) (supplied with the PN-ZR01 (optional)) with their plus (+) and minus (-) sides oriented correctly.

3.Close the cover.

TIPS

•When the batteries become exhausted replace them with new (commercially available) batteries.

•The supplied batteries (R-6 (“AA” size) x 2) may become exhausted quickly depending on how they are stored.

•If you will not be using the remote control for a long time, remove the batteries.

•Use manganese or alkaline batteries only.

Remote control operation range

The operation range of the PN-ZR01 (optional) remote control unit is approx. 23 feet (7 m) when aimed directly at the remote control sensor box. When used at an angle of approx 10° from the center to the top/bottom/right/left of the remote control sensor, use it within a distance of approx 16.4 feet (5 m).

	Remote control
	sensor
16.4 feet	16.4 feet
(5 m) 23.0 feet (5 m)
	(7 m)
10º	10º

TIPS

•Do not expose the remote control unit to shock by dropping or stepping on it. This could lead to a malfunction.

•Do not expose the remote control unit to liquids, and do not place it in an area with high humidity.

•The remote control unit may not work properly if the remote control sensor is under direct sunlight or strong lighting.

•Objects between the remote control unit and the remote control sensor may prevent proper operation.

•Replace the batteries when they run low as this may shorten the remote control’s operation range.

•If a fluorescent light is illuminated near the remote control unit, it may interfere with proper operation.

•Do not use it with the remote control of other equipment such as air conditioner, stereo components, etc.

•Adjust the angle of the PN-ZR01 (optional) remote control sensor and have it face the area where operation with the remote control unit will take place.

Connecting the Power Cord

Caution

• Use only the power cord supplied with the monitor.

1. Turn off the main power switch.

2. Plug the power cord (supplied) into the AC input terminal.

3. Plug the power cord (supplied) into the AC power outlet.

Main power switch

1

3	For power
	outlet

2

AC input terminal Power cord (Supplied)

E10