Sharp VL-Z500E Cleaning, AC Adapter, Replacing the Fluorescent Lamp, Extending battery pack life

Extending battery pack life Cleaning

Even when the battery pack is not used, the capacity of the battery pack will naturally deteriorate over time. To limit the deteriora- tion of the capacity, it is recommended to perform the following procedure at least once every six months:

1Charge the battery pack until the POWER/CHARGE (RED) indicator turns off.

2Attach the battery pack to the camcorder, and set the Power switch to v without inserting a cassette and turn off the power save mode. Allow the battery power to fully discharge by leaving it on the camcorder until the camcorder power automatically turns off.

3Remove the battery pack and store it between 10°C and 20°C.

•Many plastic parts are used in the camcorder casing. Do not use thinner, benzene or other strong chemical cleaners. These may cause discolouration and damage to the casing.

•Clean the casing with a soft, dry cloth. If the casing is particularly dirty, wipe the casing with a tightly wrung cloth damp- ened with a diluted, neutral detergent. Then wipe it again with a soft, dry cloth.

•Use a soft cloth to wipe finger marks and other smudges off the LCD screen.

•Use a soft cloth, or compressed air and lens paper designed for photographic lenses to clean the lens.

•Pull out the viewfinder and open the window cleaning cover as shown below so that you can clean up the inside of the viewfinder with a camera blower.

AC Adapter

•The AC adapter may interfere with reception if used near a radio.

•Prevent flammables, liquids, and metal objects from entering the adapter.

•The adapter is a sealed unit. Do not attempt to open or modify it.

•Do not damage, drop, or subject the adapter to vibration.

•Do not leave the adapter in direct sunlight.

•Avoid using the adapter in humid or extremely hot places.

Replacing the Fluorescent Lamp

This camcorder uses a fluorescent lamp to backlight the LCD monitor. If the monitor becomes dark or difficult to view, the fluorescent lamp may need to be replaced. Contact the nearest SHARP service centre or your dealer for further advice.

Window cleaning cover

Note:

•After cleaning, close the window cleaning cover securely. Closing the viewfinder with the window cleaning cover opened may cause malfunction.

Appendix

103