Appendix

General

Symptom

Possible cause

Suggested solution

Remote control does

REMOTE menu item is set to “OFF”.

Set REMOTE menu item to “ON”

not function.

 

(p. 49).

 

Remote control battery has run

Replace remote control battery with

 

down.

new one (p. 13).

 

Remote control used beyond oper-

Use remote control within operating

 

ating range.

range (p. 49).

 

 

 

 

Intense daylight falling on

Protect remote sensor from expo-

 

camcorder remote sensor.

sure to intense daylight (p. 49).

 

 

 

 

Obstacle between remote control

Remove obstacle or use remote

 

and camcorder remote sensor.

control from different angle (p. 49).

 

 

 

“E007” is displayed

The camcorder may be damaged.

Do not take out a cassette, and call

on the screen, and

 

for service.

unable to operate

 

 

normally.

 

 

 

 

 

Notes:

This unit is equipped with a microprocessor. Its performance could be adversely affected by external electrical noise or interference. If this should happen, turn off the power and disconnect the unit from any power sources, including the lithium battery, etc. Then reconnect the power sources to resume operation.

If the characters displayed in the viewfinder or on the LCD monitor screen appear to malfunc- tion, disconnect the power source and remove the lithium battery, then reconnect the power source, insert the lithium battery, and turn the power on again. The characters on the monitor should be normal. Set the date and time, then resume operation.

Appendix

108

Page 118
Image 118
Sharp VL-Z500E operation manual General Symptom Possible cause Suggested solution