Sharp VL-Z500E Installing the Battery to Remote Control, Close the battery holder until it clicks

Installing the Battery to Remote Control

The supplied CR2032 type lithium battery is used to power the remote control unit.

1 Insert a pointed object such as the tip of a ballpoint pen to open the battery holder.

2 Place the larger lithium battery on the battery holder with the Hside facing down.

CR2032 type lithium battery

3 Close the battery holder until it clicks.

Notes on the Use of the Lithium Battery

CAUTION: Danger of explosion if battery is incorrectly replaced. For camcorder, replace only with same or equivalent type CR1216, for remote control unit, replace only with same or equivalent type CR2032, both recom- mended by the equipment manufac- turer.

XKEEP THIS BATTERY AWAY FROM CHILDREN. IF SWAL- LOWED, CONSULT A PHYSICIAN IMMEDIATELY FOR EMERGENCY TREATMENT.

ZBATTERY MAY EXPLODE IF MISUSED OR INSTALLED WITH POLARITY REVERSED. DO NOT RECHARGE, DISASSEMBLE OR DISPOSE OF IN FIRE.

•Do not short-circuit, recharge, disassemble, or heat the lithium battery.

•Should the lithium battery leak, wipe the battery compartment clean, and then insert a new battery.

•The lithium batteries will last about one year under normal usage.

Preparation

13