Precautions
•Before recording an important scene, please perform the recording test, then playback to check if the scene was re- corded properly. If noise occurs, use a commercially available cleaning tape to clean the video heads (see page xii).
•When the camcorder is not in use, re- member to remove the cassette tape, turn off the power, and disconnect the camcorder from the power source.
•Do not aim the lens at the sun.
Do not allow direct sunlight to strike the camcorder lens, whether or not recording is in progress, as it may damage the CCD sensor. Be particularly careful when re- cording outside.
•Avoid magnetic sources.
Using the camcorder near strong fluorescent lights, motors, televisions, or other magnetic sources may adversely affect re- corded images.
•Using the camcorder near a broad- casting station or other powerful trans- mission source may cause buzzing or picture deterioration.
•Avoid shocks and dropping. Do not drop or otherwise sub-
ject the camcorder to hard shocks or strong vibrations. Bumping or striking the unit during recording will gener- ate noise in the recorded im- age.
•Avoid placing the
camcorder in close proximity to lighting equipment.
The heat from in- candescent lights may deform the camcorder, or
cause it to malfunction.
•Always respect prohibitions or restric- tions on the use of electronic equipment on commercial flights or in other sensi- tive areas.
•Be aware of the temperature and humid- ity.
You can use your camcorder at 0°C to L40°C, and at 30% to 80% relative hu- midity. Do not store the unit in an unventilated car in the summer, in direct
sunlight, or near strong heat sources; this can result in severe damage to the unit casing and cir- cuitry.
•Avoid situations where water, sand, dust or other foreign matter could get on or inside the camcorder, and do not use or leave your camcorder in areas with ex- cessive smoke, steam or moisture. Such environments can cause malfunc-
tions or cause mil- dew to form on the lenses. Be sure to keep the unit in a
• Some small, portable tri- pods may be difficult to attach and may not be sturdy enough to sup- port your camcorder. Be sure to use only a strong, stable tripod.
•When using your camcorder in a cold environment, the LCD monitor screen of- ten appears less bright immediately af- ter the power is turned on. This is not a malfunction. To prevent the camcorder from becoming too cold, wrap it in a thick cloth (a blanket, etc.).
x