Timer and sleep operation (continued)
■Sleep operation
The radio, compact disc and audio in mode can all be turned off automatically.
1Play back the desired sound source.
2Press the SLEEP button repeatedly to select the time. (Maximum: 90 minutes - Minimum: 10 minutes)
3The unit will enter the power
To confirm the remaining sleep time:
1Press the SLEEP button once.
●The remaining sleep time is displayed for about 10 seconds.
●You can change the remaining sleep time whilst it is displayed by pressing the SLEEP button (step 2).
To cancel the sleep operation:
To cancel the sleep operation without setting the unit to the
1Press the SLEEP button repeatedly to select “SLEEP 00”.
■To use timer and sleep operation together
Sleep and timer playback:
For example, you can fall asleep listening to the radio and wake up to CD in the next morning.
1Set the sleep time (see “Sleep Operation”).
2Whilst the sleep timer is set, set the timer playback (steps 2 - 14, page 13).
Sleep timer setting | Timer playback setting | End time | |||
|
|
|
|
|
|
90 minutes |
|
|
|
| Desired time |
|
|
|
| ||
Sleep operation will | Timer playback start time | ||||
automatically stop |
|
|
| ||
Enhancing your system
The connection lead is not included. Purchase a commercially available lead as shown below.
Portable audio player, etc.
Audio cable (not supplied)
MICRO COMPONENT SYSTEM
ON/
REMOTE
SENSOR
PHONES AUDIO IN
PRESET
PHONES | AUDIO IN |
■Listening to the playback sounds of portable audio player, etc.
1Use a connection lead to connect the portable audio player etc. to the AUDIO IN socket.
2Press the
3Press the AUDIO IN button.
4Play the connected equipment.
If volume level of the connected device is too high, sound distortion may occur. Should this happen, lower the volume of the connected device.
If volume level is too low, increase the volume of the connected device.
Note:
To prevent noise interference, place the unit away from the television.
■Headphones
●Do not turn the volume on to full at switch on. Listen to music at moderate levels. Excessive sound pressure from earphones and headphones can cause hearing loss.
●Before plugging in or unplugging the headphones, reduce the volume.
●Be sure your headphones have a 3.5 mm (1/8") diameter plug and impedance between 16 and 50 ohms. The recommended impedance is 32 ohms.
●Plugging in the headphones disconnects the speakers automatically. Adjust the volume using the VOLUME control.
14
