System connections (continued) |
| Remote control |
■Speaker connection
Connect the black wire to the minus
Red 
Black
Caution:
●Use speakers with an impedance of 4 ohms or more, as lower impedance speakers can damage the unit.
●Do not mistake the right and the left
channels. The right speaker is the one on the right side when you face the unit.
● Do not let the bare speaker wires touch |
|
each other. |
|
● Do not allow any objects to fall into or to be |
|
placed in the bass reflex ducts. |
|
● Do not stand or sit on the speakers. You | Incorrect |
may be injured. |
■Using antislip speaker cushions
You can install the speakers either vertically or horizontally. Affix the cushions (supplied) to the bottom of the speakers to prevent them from sliding or falling due to vibration.
(Vertical position) | (Horizontal position) |
A sheet of speaker cushions (8 pcs) is supplied with this product. Use 4 cushions per speaker.
■AC power connection
After checking all the connections have been made correctly, plug the AC power lead of this unit into the wall socket.
Wall socket
(AC 220 - 240 V ~ 50/60 Hz)
Note:
Unplug the AC power lead from the wall socket if the unit will not be in use for a prolonged period of time.
■Battery installation
1Open the battery cover.
2Insert the supplied batteries according to the direction indicated in the battery compartment.
When inserting or removing the batteries, push them towards the
battery terminals.
3Close the cover.
Precautions for battery use:
●Replace all old batteries with new ones at the same time.
●Do not mix old and new batteries.
●Remove the batteries if the unit is not to be used for long period of time. This will prevent potential damage due to battery leakage.
Caution:
●Do not use rechargeable batteries
●Installing the batteries incorrectly may cause the unit to malfunction.
●Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like.
Battery removal:
Open the battery cover and pull up the battery to take out.
Notes concerning use:
●Replace the batteries if the operating distance is reduced or if the operation becomes erratic. Purchase 2 “AAA” size batteries
●Periodically clean the transmitter on the remote control and the sensor on the unit with a soft cloth.
●Exposing the sensor on the unit to strong light may interfere with operation. Change the lighting or the direction of the unit if this occurs.
●Keep the remote control away from moisture, heat, shock, and vibrations.
■Test of the remote control
Check the remote control after checking all the connections (see pages 4 - 5).
Point the remote control directly at the remote sensor on the unit.
The remote control can be used within the range shown below: Press the
Remote sensor
0.2 m - 6 m
(8" - 20')
ON
5
