4.Adjust the projected image with the Setup Guide
1After the projector turns on, the Setup Guide appears. (When ÒSetup GuideÓ is set to ÒOnÓ. See page 44.)
2Follow the steps in the Setup Guide and adjust the focus, picture size, and height (angle).
3After adjusting the focus, height (angle) and picture size, press ENTER to finish the Setup Guide.
_PP. 26, 27
5. Correct trapezoidal distortion
Correcting trapezoidal distortion using Keystone Correction.
On the projector
Shrinks | Shrinks | |
upper side. | lower side. | |
|
|
|
|
|
|
On the remote control
_P. 28
6. Select the INPUT mode
Select the ÒCOMPUTERÓ using INPUT on the projector or COMPUTER on the remote control.
On the | On the remote | INPUT list |
| ||||||||
projector | control |
|
|
|
|
|
|
|
| ||
| INPUT |
|
|
|
|
|
| ||||
|
|
|
| COMPUTER |
|
| |||||
|
|
|
|
|
|
|
|
| |||
|
|
|
|
| COMPUTER |
|
|
| RGB |
|
|
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
| * |
|
| 1024 ⋅ 768 |
| |
|
|
|
|
|
|
|
|
|
|
| |
D
D
•When you press INPUT on the projector, the INPUT list appears. Press '/" to switch the INPUT mode.
_P. 29
7.Turn the computer on
8.Turn the power off
Press STANDBY/ON on the projector or STANDBY on the remote control, and then press the button again while the confirmation message is displayed to put the projector into standby mode.
On the | |
On the remote | |
projector | control |
_P. 25
Quick Start
17
