5Setting the Video System
The video input system mode is factory preset to “Auto”; however, a clear picture from the connected
Selectable items
Auto
PAL
SECAM
*NTSC4.43
NTSC3.58
*When reproducing NTSC signals in PAL video equip- ment.
Note
•The video signal can only be set in VIDEO or
•When “Video System” is set to “Auto”, you may not receive a clear picture due to signal differences. Should this occur, switch to the video system of the source signal.
Menu operation ⇒ Page 34
7Adjusting the Dynamic Range
An optimum picture may not be displayed if an HDMI- capable device’s output signal type and the projector’s input signal type do not match. If this should occur, switch “Dynamic Range”.
Selectable items | Description | |
Auto | In most circumstances, “Auto” should | |
| be selected. | |
|
| |
Standard | When the black levels of the image | |
| show banding or appear faded, select | |
Enhanced | ||
the item that results in the best picture | ||
| ||
| quality. |
8Signal Info
Input signal information is displayed.
6Setting the Video Setup
Selectable items | Description |
0 IRE | Sets the black level to 0 IRE. |
7.5 IRE | Sets the black level to 7.5 IRE. |
Note
•This can be used for a 480I signal connected to the COMPONENT terminal or the COMPUTER/ COMPONENT terminal.
•This can be used for an NTSC3.58 signal con- nected to the VIDEO or
Useful Features