Before You Begin

Connecting Your Organizer to a PC

1.Turn off your PC and the Organizer.

2.Connect the standard 9-pin connector of the PC interface cable to a COM port on your PC.

Using a 25-pin connector instead of the standard 9-pin connector requires an additional adaptor. (Commercially available.)

3.Connect the other end of the PC Interface Cable to the PC interface connector located on the left side of the Organizer.

PC Interface Cable

Installing

1.Insert the PC Interface Software disk into your disk drive.

2.Click on the Windows [Start] button and then click [Run].

3.Type in a:\Setup.exe and click on [OK].

• Type in your disk drive name (a:\ in this example).

4.Follow the on-screen instructions.

The software is installed into the following location and can be accessed in the following directory:

C:\Program Files\Sharp YOZQ-270\

Application:

[Start] [Program] [Sharp YOZQ-270] [EO-Utility]

ReadMe:

[Start] [Program] [Sharp YOZQ-270] [ReadMe]

You are recommended not to change the default folder name: [Sharp YOZQ-270].

5.Click [Finish].

Note:

For Windows 2000, install the software after logging on authorized as system administrator.

26

Page 28
Image 28
Sharp YO-270 Before You Begin Connecting Your Organizer to a PC, Installing, Program Files\Sharp YOZQ-270\ Application