Sharp YO-270 operation manual Using the Organizer for the First Time

Using the Organizer for the First Time

Be sure to perform the following operations before using the Organizer for the first time.

1. Pull out the battery insulation sheets from the battery compartment.

The Organizer starts operation.

(The battery insulation sheets were inserted at the factory to prevent battery wear.)

2.Press the RESET switch.

A message, “CLEAR ALL DATA OK?” is displayed.

3.Use jor lto select “Yes” and press x.

The message will appear as "Do you really want to initialize the organizer's memory?"

4.Select “Yes” using jor land press x.

The Organizer is now initialized. Proceed to set the date and time of the clock (Refer to page 6).

Note

•Press the RESET switch with a ball-point pen or similar object. Do not use an object with a breakable or sharp tip.

If a malfunction occurs under abnormal conditions

If the organizer is subjected to strong extraneous electrical noise or shock during use, on rare occasions, all the functions will not work properly and data may be displayed incorrectly. In such cases, follow the procedures as shown below.

1.Press RESET.

2.When a message, "CLEAR ALL DATA OK?" is displayed, select "No" and press x.

If the first procedure doesn't work, follow the next procedure to initialize the organizer's memory. In this case, all the stored data will be deleted.

1.Press RESET.

2.When a message, "CLEAR ALL DATA OK?" is displayed, select "Yes" and press x.

1