Operations
•To use the system remote control unit of Sherwood system receiver
PLAYING BACK A TAPE
Turn the power on.
1 | ON/STANDBY |
|
|
| • Each time the POWER(ON/STANDBY) button is |
|
| pressed, this unit is turned on or off. |
2 | Load a tape. |
|
OPEN/CLOSE | • According to the type of the tape loaded, the | |
| corresponding type(normal, chrome) is detected by |
the auto tape selector.
Note: Do not open or close the tape tray by force. Doing so may damage it.
ENGLISH
In case of the tape recorded with Dolby
3 B NR system, select the Dolby B NR mode.
| 1 | 2 | 3 |
DOLBY | 4 | 5 | 6 |
7 | 8 | 9 |
SYSTEM REMOTE | |
| CONTROL UNIT |
| (only for |
•Each time this button is pressed, the Dolby B NR mode changes as follows:
DOLBY B NR(“B” light up) OFF
•On the commercial tapes, if Dolby NR or “ ” appears, the tapes are recorded with the Dolby B NR.
Select the desired reverse mode.
4
1 | 2 | 3 |
|
4 | 5 | 6 | REV.MODE |
7 | 8 | 9 |
SYSTEM REMOTE | |
| CONTROL UNIT |
| (only for |
•Each time this button is pressed, the reverse mode is selected as follows:
: Playback of a single side.
: Playback of both sides. (Front side Back side)
: Repeat playback of both sides. (Front side Back side )
Start playback.
5
Back side | Front side |
or
TAPE
SYSTEM REMOTE
CONTROL UNIT
(only for
•Each time “TAPE ” button pressed, the corresponding side is played back.
•At the end of the tape, according to the reverse mode, the playback of the next side starts or the playback of the current side stops automatically.
9