Sherwood R-903R manual Using Functions of Remote Control, Entering a setup code

USING FUNCTIONS OF REMOTE CONTROL

•This remote control can control up to 8 different components.

•Before operating audio and video components other than this receiver with using this remote control, the setup code for each component should be entered.

•For system remote control operation, “000” was stored previously in the memory of the device button “CD” for Sherwood CD player, “DVD” for Sherwood DVD player and “AUX” for Sherwood tape deck respectively as its factory setup code. So, you don’t need to enter its code for each Sherwood component except in such a case that its code does not work.

Entering a setup code
1	Turn on the component you want to control				2	Find the setup codes according to the type
						and the brand name of your component,
						referring to “SETUP CODE TABLE” on
						page 45.
3	Press and hold down both the ENTER				4	Enter a 3 digit code, aiming the remote control
	button and the DEVICE button you want					at the remote sensor on the component.
	for more than 1 second.					Example) When entering “001”.
				DEVICE	0	0 1
AUDIO CD		AUX	TV	buttons
VCR	DVD	CABLE	SAT
	MACRO
M1	M2	M3
		T/V
					• If entering is performed successfully, the LED will
					flicker twice.
					• To be sure that the setup code is correct, press the
					POWER(or STANDBY) button.
				ENTER	If your component is tuned off, the setup code is correct.
					• When your component is not turned off, repeat the
					above steps 2 to 4, trying each code for your component
					until you find one that works.
• The LED will flicker once.					Notes:
Note:					• If the LED did not flicker twice, then repeat the above
• The AUDIO button is unavailable for the audio					steps 3 to 4 and try entering the same code again.
components other than this receiver.					• Manufacturers may use different setup codes for the
					same product category. For that reason, it is important
					that you check to see if the code you have entered
5	Repeat the above steps 1 to 4 for each of				operates as many controls as possible. If only a few
					functions operate, check to see if another code will
	your components.
					work with more buttons.

13

ENGLISH