32
ENGLISH
Repeat the above steps 1 to 3 to memorize
other stations.
4
After selecting the tuner as an input
source, select the preset mode.
1
• The station has now been stored in
the memory.
• A stored frequency is erased from
the memory by storing another
frequency in its place.
• If “MEM” goes off, start again from
the above step 2.
• Then “PRESET” lights up. • When pressing the PRESET +/- buttons on the
remote control, you need not select the preset mode
on step 1.
Tuning to preset stations Select the desired preset number.
2
Select the desired preset number (1~30) and press the MEMORY button.
3
SETUP
MEMORY
DECODING
TUNE MODE
Presetting radio stations
• You can store up to 30 preferred stations in the
memory.
• “MEM” is flickering for 5 seconds.
Tune in the desired station with auto or
manual tuning.
1
Press the MEMORY button.
2
SETUP
MEMORY
Scanning preset stations in sequence
• The receiver will start scanning the stations in the preset
sequence and each station is received for 5 seconds.
• At the desired station, press this button again to stop
scanning.
• When pressing this button without selecting the tuner,
the tuner will be selected automatically.
or
ADJUST
TUNING/PRESET
PRESET
-, +
or
ADJUST
TUNING/PRESET
PRESET
-, +
P.SCAN