28
ENGLISH
• Each adjustable range of bass and treble is -10~+10.
• In general, we recommend the bass and the treble to
be set to 0(flat) level.
• At “TONE ON” mode, you can select “TONE OFF”
mode and vice versa.
TONE ON: When adjusting the tone for your taste.
(“DIRECT” indicator goes off.)
TONEOFF: When listening to a program source
without the tone effect.
(“DIRECT” indicator light up.)
• When using this function with remote control unit,
press OSD button and refer to page 38~40.
Notes:
• If the display of the corresponding mode disappears, start from the step 1 again.
• Extreme settings at high volume may damage your speakers.
• When the digital signals from DTS, Dolby Digital or MPEG program sources are input in available surround
mode, you cannot adjust the tone and can hear a program source without the tone effect.
While displaying the desired tone mode,
adjust the tone as desired.
3
ADJUST
TUNING/PRESET
Compressing the dynamic range (Dolby Digital sources only)
• This function compresses the dynamic range of previously specified parts of the Dolby Digital sound track(with
extremely high volume) to minimize the difference in volume between the specified and non-specified parts.
This makes it easy to hear all of the sound track when watching movies at night at low levels.
• Only when the digital signals from Dolby Digital program source are input in available surround mode, the
dynamic range can be adjusted.
SETUP
MEMORY
Press the SETUP button for more than 2
seconds, then it enters the setup mode.
While displaying the setup mode, press this
button short repeatedly until “DYNR 0.0” is
displayed.
1
• Each time the ADJUST UP( ) or DOWN( ) button is pressed, the mode
changes as follows:
DYNR 0.0 : Off
DYNR 0.5 : Low compression
DYNR 1.0 : High compression
• When using this function with remote control unit, press OSD button and refer to
page 38~40.
Notes:
• If the display of the dynamic range mode disappears, start from the step 1 again.
• In some Dolby Digital softwares, this function may not be available.
ADJUST
TUNING/PRESET
While displaying “DYNR 0.0”, select the desired mode.
2