Sherwood R-903R manual Adjusting the LFE level, Adjusting the tonebass and treble

Adjusting the LFE level

•You can adjust the LFE(Low Frequency Effect) levels included in Dolby Digital, DTS and MPEG program sources.

Press the SETUP button for more than 2

1 seconds, then it enters the setup mode. While displaying the setup mode, press this button short repeatedly until “DD L” is displayed.

SETUP

MEMORY

While displaying “DD L”, each time the

2 button below is pressed, the mode changes as follows:

DECODING

TUNE MODE

DD L	DTS L	MP L
(Dolby Digital LFE)	(DTS LFE)	(MPEG LFE)

ENGLISH

3	While displaying the desired LFE mode,
	adjust the level as desired.

ADJUST

TUNING/PRESET

•The Dolby Digital LFE level can be adjusted within the range of -10~0 dB and other LFE levels within the range of -10~+10 dB.

•In general, we recommend the LFE level to be adjusted to 0 dB.(However, the recommended LFE level for some early DTS software is -10 dB.) If the recommended levels seem too high, lower the setting as necessary.

•When using this function with remote control unit, press OSD button and refer to page 38~40.

•The LFE level can be adjusted and applied when Dolby Digital, DTS or MPEG program source is inputted. In case of other program sources, this mode is adjustable, but not applied.

Adjusting the tone(bass and treble)

Press the SETUP button for more than 2

1 seconds, then it enters the setup mode. While displaying the setup mode, press this button short repeatedly until “TONE OFF” or “BASS” is displayed.

SETUP

MEMORY

While displaying “BASS”, each time the

2 DECODING button is pressed, the tone mode changes as follows:

DECODING

TUNE MODE

BASS TRBL(treble) TONE ON

•While displaying “TONE OFF”, you cannot adjust the tone. To adjust the tone, first perform the step 3 and change “TONE OFF” to “TONE ON”.

27