Sherwood RD-6503 manual When CD, Video 1~ 2 is selected as an input source

When CD, VIDEO 1~ 2 is selected as an input source

4. Select the digital or the analog input connected as desired.

or

•Each time this button is pressed, the corresponding input is selected as follows:

→o(ptical) → c(oaxial)1→ c(oaxial) 2 → A(nalog)

■Notes :

•When AUX, F AUX, TAPE, BT IN, EXT IN, USB IN or tuner is selected as an input source, the digital input cannot be selected.

•When the selected digital input is not connected, the "DIGITAL" indicator flickers and the analog input is automatically selected.

•The selected digital or analog input is automatically assigned to the corresponding input source on the INPUT setup menu. (For details, refer to "SETTING THE INPUT " on page 36.)

•The sound from the component connected to the selected digital input can be heard regardless of the selected input source.

5.Operate the selected component for playback.

•When playing back the program sources with surround sound, refer to “ENJOYING SURROUND SOUND” on page 18.

6. Adjust the (overall) volume.

or

DOWNUP

7. To mute the sound.

•“MUTE” will flicker.

•To resume the previous sound level, press it again.

8. To listen with the headphones.

•Be sure to switch the speakers off.

•When listening to a DTS or Dolby Digital program source, if the headphones are plugged in and the SPEAKER button is set to off, it enters the 2CH downmix mode automatically. (For details, refer to "2CH downmix mode" on page 18.)

■Note :

•Be careful not to set the volume too high when using headphones.

ENGLISH

15