Sherwood RD-6503 Adjusting the current channel level, Press the CHANNEL LEVEL button, English

Adjusting the current channel level

•After adjusting each channel level with test tone, adjust the channel levels either according to the program sources or to suit your tastes.

•You can adjust the current channel levels as desired. These adjusted levels are just memorized into user’s memory ("CAL"), not into preset memory("REF 1", "REF 2").

1. Press the CHANNEL LEVEL button.

or

• Then the memory mode ("REF 1", etc.) is displayed for several seconds.

• When the memory mode or channel level disappears, press this button again.

2. Select the desired channel.

	• Each time these buttons are pressed, the corresponding
	channel is selected as follows:
	REF 1, 2 (or CAL)	FL	C	FR
	<DTS or DD>	SW	SL	SR
	< >: Only when the digital signals from Dolby Digital or DTS
or	program sources that include LFE signal are input, LFE level
	can be displayed.

• Depending on the speaker settings ("N (None or No)") and surround mode, etc., some channels cannot be selected.

• When the SPEAKER button is set to off, only the Front Left and Front Right channels can be selected.

3. Adjust the level of the selected channel as desired.

• The LFE level can be adjusted within the range of -10~0 dB and other channel levels within the range of -15 ~ +15 dB.

• In general, we recommend the LFE level to be adjusted to 0 dB. (However, the recommended LFE level for some early DTS software is -10 dB.) If the recommended levels seem too high, lower the setting as necessary.

4. Repeat the above steps 2 and 3 to adjust each channel level.

ENGLISH

21