Sherwood SD-860 CHANGING THE VIDEO SIGNAL FORMAT, CHANGING THE COMPONENT VIDEO OUTPUT SIGNAL

CHANGING THE VIDEO SIGNAL FORMAT

• Depending on the countries, this unit conforms to either the NTSC color system for U.S.A, Canada, etc., or the PAL for

Europe, Australia, China, etc.

If the color system of this unit is different from that of your TV monitor and the discs to be played, the screen may be

somewhat hard to see or the picture quality may be poor.

Only in this case, change the video signal format to another.

(For details about the video signal format of your TV monitor or the discs, refer to the operating instruction of your TV or the

disc’s jacket.)

• You can set the video signal format to the desired at initial settings, too.

(For details, refer to “When selecting the TV TYPE” on page 33.)

• In the stop mode, press the NTSC/PAL button.

• Each time this button is pressed, the video signal format

changes as follows:

󳂵MULTI 󳂵NTSC 󳂵PAL

• The MULTI is compatible with both NTSC and PAL formats.

CHANGING THE COMPONENT VIDEO OUTPUT SIGNAL

• The COMPONENT VIDEO OUTPUTs of this unit can be capable of outputting either conventional interlacing video signal or

progressively scanned video signal(that can reproduce high-density pictures with less flicker).

• When the COMPONENTVIDEO OUTPUTs of this unit are connected to the COMPONENT VIDEO INPUTs of TV or

projector, etc., depending on whether the video signal system of your TV or projector, etc. supports the conventional

interlacing(simply called interlaced) video signals or the progressively scanned(simply called progressive) video signals(that

can reproduce high-density pictures with less flicker), you should select the corresponding video signal.

• You can set the component video output signal to the desired at initial settings, too.

(For details, refer to “When selecting the VIDEO OUTPUT” on page 34.)

Notes:

• When you select the PROGRESSIVETV, the S-VIDEO and COMPOSITE VIDEO OUTPUTs of this unit cannot output the

video signals, meaning the picture will not be shown.

• When the progressive video signals are input into the non-progressive COMPONENT VIDEO INPUTs of your TV, etc., the

picture may not be shown normally.

Therefore, when the progressive COMPONENT VIDEO INPUTs of TV is not connected to, you should select INTERLACE

TV.

• In the stop mode, press the UPSCALE button.

• Each time this button is pressed, the component video

output signal changes and “INTERLACETV” or

“PROGRESSIVE TV” is displayed on the TV screen.