Maxtor 16Channel Stand Alone DVR Spot Monitor Setup, ※ Event POP-UP Duration, Switching Interval

CHAP. 5 Set Up

4) SPOT MONITOR SETUP

SPOT MONITOR SETUP
SWITCH INTERVAL	03 SEC
ALARM POP UP	ON
MOTION POP UP	ON
EVENT POP UP DURATION	01 SEC

SELECT: ▲▼, CHANGE VALUE : + -

※EVENT POP-UP DURATION

Set EVENT POP-UP DURATION

(1) SWITCHING INTERVAL

Channel switching time (01 sec. ~ 99 sec.)

(2) ALARM POP-UP

When ALARM is detected, the image of channel connected with Alarm sensor pops up.

Set ALARM detection pop-up (ON/OFF)

(3) MOTION POP-UP

Set MOTION detection pop-up (ON/OFF)

If events (MOTION or ALARM) happen on several channel at the same time, channel No. 1 has the first priority to pop up. For example, if events happen on channel No. 1, channel No. 2, and channel No. 4 at the same time, channel No. 1 pops up. If the motion disappears on channel No. 1, then channel No. 2 pops up for the duration that you set. However, even though motion happens on channel No. 1 again within the duration, channel No. 2 still displays. If motion on channel No.1 keeps on going even after the duration, channel No. 1 pops up again.

5) AUDIO SETUP

Use direction button to move to channel and Press [ENTER] button to set (ON/ OFF).

AUDIO SETUP

1) REC

CH	REC	PLAY	(1) ON : Record images with AUDIO
01	ON	ON	(2) OFF : Record images without AUDIO
02	ON	ON	2) PLAY
03	ON	ON
04	ON	ON	(1) ON : Recorded sound comes out during

playback

(2) OFF : Recorded images only play back

SELECT: ▲▼◀▶, & [ENTER]

33