Assembly: AH2510
Spark Plug
| Clamp Screw |
Outer Tube | Mainshaft |
| |
Grip |
|
Trigger
Housing
Tube
Clamp
Figure 5
| Connect the Outer Tube | ||
CAUTION! | |||
to the Powerhead. | |||
Do not force the shaft tube into the | |||
1. | Place the powerhead on a clean, flat | ||
powerhead! Excessive force can dam- | |||
age the shaft tube and mainshaft. |
| surface, spark plug facing up. | |
| 2. | Use the 4 mm hex wrench to loosen the | |
| |||
|
| tube clamp screw. |
Tube Clamp
Hex
Wrench
Figure 6
3.Slide the outer tube into the tube clamp until the tube bottoms. If installation is difficult, rotate the outer tube or main shaft slightly until you feel the mainshaft splines engage with the powerhead.
4.Position the outer tube so that the gearcase output shaft is facing left on muffler cover.
5.Slide the outer tube into the powerhead until the throttle grip just contacts the tube clamp.
6.Tighten the clamp screw firmly.
Throttle Cable
Connect the Throttle Cable
1. Loosen the air cleaner cover knob |
and remove the air cleaner cover. |
See Figure 7. |
Filter
Cover
Connect the throttle
cable
Throttle
Cable
2. Slip the throttle cable into the cable |
adjuster and hook the bullet end of the |
cable onto the swivel. See Figure 8. |
Connect the Ignition Leads
3.Connect the two ignition wires by pushing the bullet connectors together. See Figure 9.
4.Reinstall the air cleaner cover.
CAUTION!
Routing of wiring must not interfere with throttle or choke operation.
Figure 7
Ignition
Lead
Figure 9
Figure 8
Cable
Adjuster
Cable Swivel