NOTE:
Very little visible oil on the saw chain will provide sufficient lubrication.
Adjust the pump as follows:
1.Stop the engine and make sure the stop switch is in the OFF position.
2.Place the unit on its side with the oil reservoir (D) up.
3.Using a screwdriver, turn the oil flow rate adjustment screw (E) in the desired direction:
•
•counter
Starting Engine – Interlock Throttle Controls
IMPORTANT!
The engine ignition is controlled by a
WARNING!
The attachment will operate immediately when the engine starts, and could result in possible serious injury. Keep movable parts of the attachment away from objects that could become entangled or thrown, and surfaces that could cause loss of con- trol.
Control Positions (cold engine)
1.Slide the ignition switch (A) to the “ON” position.
2.Set the throttle trigger to the “fast idle”:
a.Depress and hold the throttle lock (B), then squeeze the throttle trigger.
b.Depress and hold the fast idle button (C).
c.Release the throttle trigger and throttle lock, then release fast idle button.
3.Press the purge bulb (D) four or five times. You should be able to see fuel inside the bulb.
4.Choke the engine by moving the choke lever (E) up to the “closed” position.
Control Positions (warm engine)
1.Set the throttle trigger to “fast idle”
2.Slide the ignition switch to the “I” (ON) position.
3.Moving the choke lever down to the “open” position.
C
B
A
D
E
P23007
13
