Shindaiwa T230 manual Reconnecting the Throttle Cable, Switch Wires, Adjusting the Throttle Cable

Reconnecting the Throttle Cable, Switch Wires

Connect The Throttle Cable.

1.Loop the ribbed cable assembly to the top left side of the engine. Confirm that the black ground wire (A) (with an eyelet on the end) is located between the two cable adjuster nuts (B).

2.Connect the Z-shaped end of the throttle cable (C) to the throttle lever on top of the carburetor.

3.Turn the cable adjuster nuts sufficiently for the throttle cable to fit in the notch

(D) on the fan cover. Make sure the ignition ground lead is located on the rear- ward side of the notch. Then, connect the male fitting of the red ignition wire into the female fitting of the red wire attached to the engine (E).

C

Adjusting the Throttle Cable

1. Loosen the two 10mm throttle cable nuts (B).

B

D

C

A

E

B

8