16
n Remove the spark plug and pour about
1/4 ounce of 2-cycle mixing oil into the
cylinder through the spark plug hole.
Slowly pull the recoil starter 2 or 3 times
so oil will evenly coat the interior of the
engine. Reinstall the spark plug.
n Befor e storing the unit, repair or replace
any worn or damaged parts.
n Remove the air cleaner element from the
carburetor and clean it thoroughly with
soap and water. Let dry and reassemble
the element.
n Stor e the unit in a clean, dust-free area.
Whenever the unit will not be used for
30 days or longer, use the following
procedures to prepare it for storage:
n Clean exter nal parts thoroughly.
n Drain all the fuel from the fuel tank.
IMPORTANT!
All stored fuels should be stabilized with a
fuel stabilizer such as STA-BIL™, if
oil with fuel stabilizer is not used. 1. Prime the primer bulb until no more fuel
is passing through.
2. Star t and run the engine until it
stops running.
3. Repeat steps 1 and 2 until the engine will
no longer start.
CAUTION!
Gasoline stored in the carburetor
for extended periods can cause hard
starting and could also lead to
increased service and maintenance
cost.
When the cutting edges of the blade
become dull, they can be resharpened with
a few strokes of a file.
In order to keep the blade in balance, all
cutting edges must be sharpened equally.
Shindaiwa Tornado™ Blade
To sharpen the cutters on a Shindaiwa
Tornado™ Blade, use a 7/32-inch round
file. File the leading edge of each tooth to
a razor edge. The top plate of each tooth
should angle back 30°.
WARNING!
Sharpen only the cutting teeth
of a blade. DO NOT alter the contour
of the blade in any way.
Multiple-tooth Circular Blade
Use a round file to maintain a radius of 0.04
to 0.06” (1 to 1.5 mm) at the base of each
tooth. Cutting edges must be offset equally
on each side.
Round
File
30°
Round
File
Figure 32
Figure 31
n Remove the r emaining fuel from the
fuel lines and carburetor.