Emission Control (Exhaust & Evaporative)
EPA 2010 and Later and/or C.A.R.B. TIER III
The emission control system for the engine is EM/TWC (Engine Modification and
An Emission Control Label is located on the unit. (This is an EXAMPLE ONLY; information on label varies by en- gine FAMILY).
PRODUCT EMISSION DURABILITY (EMISSION COMPLIANCE PERIOD)
The 300 hour emission compliance period is the time span selected by the manufacturer certifying the engine emissions output meets applicable emissions regulations, provided that approved maintenance procedures are followed as listed in the Maintenance Section of this manual.
Assembly
Prior To Assembly
Before assembling, make sure you have all the components required for a complete unit:
■■Hedge Trimmer Assembly
■■Kit with this manual and tool kit for routine maintenance.
■■Cutter blade cover
Carefully inspect all components for damage.
IMPORTANT!
The terms “left”,
Adjusting the Hedge Trimmer Cutter Assembly
WARNING! | Adjustment Lever |
|
Never run the engine when adjusting the cutter assembly.
WARNING! |
| Grasp the outer tube near the handle |
|
| |
■■The cutter blades are very |
|
|
| Latch Lock | |
|
| |
sharp. Do not grasp the blades |
|
|
with your hands. Always use |
|
|
gloves when working near the |
|
|
cutter assembly. |
|
|
■■Do not allow the blades to con- |
|
|
tact your body. |
| Latch Release |
■■Do not touch the cutter blades |
| |
| Press the latch lock | |
when the engine is running. |
|
|
|
| |
| IMPORTANT! | |
The blades can oscillate even |
| |
| The latch lock provides an interlock to | |
if the engine is idling. |
| |
|
| help prevent inadvertent depression of |
|
| the latch release. |
|
Latch Lock
Pivot the cutter assembly using the
adjustment lever...
Adjustment Lever
Make sure the latch lock and the latch release return securely to the locked position
5. Release the latch lock and the latch |
release. Make sure the latch lock and |
the latch release return securely to |
1.Position the hedge trimmer on a flat, level surface.
2.With your right hand, grasp the outer tube near the handle. With your left hand, grip the adjustment lever on the cutter assembly.
3.With the index finger of your left hand, press the latch lock. With your left thumb, press the latch release.
4.While holding the latch release down, pivot the cutter assembly away from you using the adjustment lever until it is at the desired cutting angle.
the locked position. |
6. Remove the cover from the cut- |
ter blade. The engine now may be |
started (refer to the section ”Start- |
ing the Engine”.) |
7