Maintenance (continued)
Gearcase lubrication
■■Lubricate the cutter assembly gearcase by pumping one or two strokes of
CAUTION!
Over lubricating can cause the gear- case to operate sluggishly and can cause grease to leak out.
50-hour maintenance
Every 50 hours of operation; more
frequnetly in dusty conditions:
■■ Remove and clean the cylinder cover and clean dirt and debris from the cylinder cooling fins.
Remove and replace the fuel filter element.
■■Use a hooked wire to extract the fuel filter from inside the fuel tank. Inspect the fuel filter element. If it shows signs of contamination, replace with a genuine Shindaiwa replacement fuel filter element.
CAUTION!
Make sure you do not pierce the fuel line with the end of the hooked wire. The line is delicate and can be dam- aged easily.
Before reinstalling the new filter element, inspect the condition of all the fuel system components (fuel
Gearcase lubrication
To perform this operation, first remove the gearcase from the outer tube as follows:
1.Loosen the gearcase clamp bolt.
2.Remove the index bolt from the gearcase.
A
Lubricate cutter assembly and gearcase | Gearcase |
| grease fitting |
Hooked wire
Fuel filter element
Remove and replace the fuel filter element
Gearcase lubrication | Gearcase Clamp |
Outer Tube
Gearcase
Remove and replace the fuel filter element
Index Bolt
16