Shopsmith 555970 manual Overarm Router Assembly, Tools & Supplies Needed

MARK V – MOUNTED OVERARM PIN ROUTER 555970

4.Motor Brackets – Firmly hold any round, hand-held router motor from 2-1/2" to 4" in diameter. These dimen- sions are for the motor only (the router base is removed during operations).

5.Brass Gib – Adjusts with four Allen set screws to eliminate side-to-side move- ment of the motor while allowing smooth, vertical movement of the dove- tail slide.

6.Depth Stop Rod – Locks into any po- sition to limit your depth-of-cut during operations.

7.Dovetail Assembly – Moves up-and- down by means of a steel rack-and-pin- ion gear mechanism. The dovetail slide provides 3-1/2" of vertical motor travel.

8.Depth Control Handle – Conveniently raises and lowers the router motor. A simple twist locks the handle in place.

9.Circular Table Inserts – Two provided: One with a 1-3/8" diameter center hole and an offset threaded insert for the Starting Pin (included) . . . and another with a center threaded insert for the three interchangeable Overarm routing Guide Pins (three included: 1/4", 3/8" and 1/2" diameters).

10.Two-Piece Router Fence – Adjustable aluminum Fences attach to the Work- table mounting holes with threaded plastic Knobs, Spacers and washers for straight-line routing operations.

11.MARK V Way Tube Mounting Brack- ets – Upper and lower Mounting Brack- ets attach to the Overarm . . . then around the MARK V Way Tubes with mating Clamps, supporting the Overarm Router above the Worktable.

12.Mounting Bracket Clamps – Clamp around the “back side” of your Way Tubes with 3" long x 3/8" dia. socket

head capscrews, threaded into the holes on the back sides of the Mounting Brackets.

13.SLIDING T-Nuts – Used to attach your Overarm Router Table to your Model 505, 510 or 520 MARK V Worktable.

OVERARM ROUTER ASSEMBLY

WARNING

Your safety and the ability to use your new Shopsmith Overarm Pin Router properly depends on your following these assembly and use instructions exactly.

NOTE

Reference numbers that appear in paren- theses following the part names correspond with the numbers on the figures in this sec- tion and the exploded view in the Parts List section of this Manual.

TOOLS & SUPPLIES NEEDED:

•1/8" Allen wrench

•5/32" Allen wrench

•1/4" Allen wrench

•5/16" Allen wrench

•7/16" Open end wrench

•Furniture or floor paste wax (do NOT use car wax or spray furniture polish)

•Mineral spirits

•Fine file or emery cloth (optional)

11