![](/images/new-backgrounds/1015197/1519783x1.webp)
APOGEE Heat Pump Controller –
Ordering Replacement Parts
If a controller is not operating correctly, order a new controller. The product number for ordering a replacement controller is the controller product number preceded by an "R". The replacement product numbers for accessories are the same as new product numbers:
Unit Vent Controller – 0 to 10V Output | |
CE Compliant Unit Vent Controller – 0 to 10V Output |
Preventive Maintenance
Most controller components are designed so that, under normal circumstances, they do not require preventive maintenance. Periodic inspections, voltage checks, and point checks are normally not required. The controller's rugged design makes most preventive maintenance unnecessary. However, devices that are exposed to dusty or dirty environments may require periodic cleaning to function properly.
Safety Features
The controller board stores the controller's address, applications and point values. In the event of a power failure or a reset, these values are retrieved from the controller's permanent memory and are used by the controller unless overridden by a field panel. If one of the following conditions occurs, the controller will activate safety features present in its
•Sensor failure.
•Loss of power. Upon controller power loss, communication with the controller is also lost. The controller will appear as failed (*F*) at the field panel.
Controller LEDs
To determine if the controller is powered up and working, verify that the Basic Sanity Test (BST) Light Emitting Diode (LED) is flashing ON/OFF once per second. The controller contains eleven LEDs located on the circuit board. See the Controller LED indicators section of Chapter 1, Product Overview for more information about LEDs.
NOTE: The TX and RX LEDs indicate communication over the FLN.
32 | Siemens Building Technologies, Inc. |