Siemens 6DS2-510-0xx00-0xa0 manual Configuration of the bus connections, L2AMPRO.INI

Product Information	February, 1999
BRIDGE CS-L2

6 Configuration of the bus connections

The parameters for the BRIDGE CS-L2 are set in the configuration files BR_SYS.INI, DOS_CONF.DAT (or L2AMPRO.INI) and SYS_PAR.INI .

)Subsequent parameters for BRIDGE CS-L2 should be set individually. In doing this you should ensure compatibility with the other bus participants.

	DOS_CONF.DAT	BR_SYS.INI	Remark
	resp.
	L2AMPRO.INI
station address TA	l2_ts=xx [dez]	BATA=yyxx [hex]	yy = BA
			xx = TA
bus address BA	____	BATA=yyxx [hex]	yy = BA
			xx = TA
range	____	RANGE=xx [hex]	Bridge filter
highest station address	l2_hsa=xx [dez]	____	of all stations at the
			PROFIBUS-TM
CS275 redundancy	____	REDUNDANZ=x	x = 1: redundant
			x = 0: non redundant

If the coupling module CP5412-A1 is used for the PROFIBUS-TM (SINEC L2) system bus, the DOS_CONF.DAT initialization file must be used (see Chapter 6.2).

If, however, the IF964-DP interface module is used, the L2AMPRO.INI initialization file must be used (see Chapter 6.3).

Copyright © SIEMENS AG 1996-1999. All Rights Reserved. S79220-A0978-A-05-7637 Page 12 of 20