Opening lists with the message key
An advisory tone sounds as soon as a new entry appears on a list. The fkey flashes (it goes off when the key is pressed). In idle status, the displays shows an icon for the new message.
If you press the fkey, you access the lists which contain new messages.
Using a handset as a room monitor
If the room monitor is activated, a previously stored destination number is called as soon as a set noise level is reached. You can store an internal or external number in your handset as the destination number.
The room monitor call to an external number stops after approx. 90 seconds. The room monitor call to an internal number (handset) stops after approx. 3 minutes (depending on the base station). While the room monitor is activated, all keys are locked except the end call key. The handset's speaker is muted.
When the room monitor is activated, incoming calls to the handset are indicated without a ringtone and are only shown on the screen. The display and keypad are not illuminated and advisory tones are also turned off.
If you accept an incoming call, the room monitor mode is suspended for the duration of the call, but the function remains activated.
If you switch off the handset, the room monitor mode is deactivated. You must reactivate the function after switching on the handset again.
Using a handset as a room monitor
Caution!–You should always check the operation of the room monitor before use. For example, test its sensitivity. Check the connection if you are diverting the room monitor to an outside number.
–When the function is switched on, the handset's operating time is severely reduced. If necessary, place the handset in the charging cradle. This ensures that the battery pack does not run down.
–Ideally the handset should be positioned 1 to 2 metres away from the baby. The micro- phone must be directed towards the baby.
–The connection to which the room monitor is diverted must not be blocked by an acti- vated answering machine.
Activating the room monitor and entering the number to be called
v¢í¢Room Monitor
¤ Change multiple line input:
Room M.:
Select On to activate.
Call to:
Press the display key §Edit§ and enter destination number.
External number: select number from the directory or enter directly. Only the last 4 digits are displayed.
Internal number: delete any stored external number. §INT§ s(select handset or Call All , if all registered handsets are to be called) §OK§.
Store number with §Save Entry§ §OK§.
Level:
Set noise level sensitivity (Low or High).
¤Save changes (page 21).
The function is now activated. With v, you can move directly to settings.
13