Safety precautions
Notes:
–Automatic registration is not possible when the base station on which you wish to reg- ister the handset is being used to make a call.
–Each key press interrupts the automatic registration.
–If automatic registration does not work, you will have to register the handset manu- ally.
Manual registration of the Gigaset E45
If the handset does not activate automatically when the battery pack is fitted, you must first charge the battery pack.
You must activate manual registration of the handset at both the handset and the base station.
After it has registered, the handset returns to idle status. The handset's internal number is shown in the display e.g. INT 1. If not, repeat the procedure.
1. On the handset
v¢Ð¢Handset ¢Register H/Set
sSelect base station, e.g. Base 1, and press §OK§.
~Enter the system PIN of the base station (the default is 0000) and press §OK§. The screen will display, e.g. Base 1.
2. On the base station
Within 60 secs. press and hold the regis- tration/paging key on the base station (page 1) (approx. 3 secs.).
Headset socket
You can connect the following types of headset (with jack connector): HAMA Plantronics M40, MX100 and MX150.
If you do not connect a headset, please insert the cover supplied for the headset socket to guarantee the unit is still splash proof.
Charging the battery pack
¤Plug the mains adapter of the charging cradle into a mains power socket.
¤Place the handset in the cradle with its display facing forward.
To charge the battery pack, leave the handset in the charging cradle. If the handset is activated, the flashing battery icon ein the top right of the display indicates that the battery pack is being charged. During handset operation, the battery icon indicates the charge status of the battery pack (page 1).
Initial charging and discharging of the battery pack
The correct charge status can only be displayed if the battery pack is first fully charged and discharged.
¤To do this, leave the handset in the charging cradle continuously for ten hours. Your handset need not be switched on for it to charge.
¤Afterwards, remove the handset from the charging cradle and do not put it back again until the battery pack is fully discharged.
Notes:
–The handset should only be placed in a base station or charging cradle that is designed for it.
–When the handset is in the cradle, it charges even if it is switched off.
–If the handset has switched itself off because the battery pack is flat and it is then placed in the cradle, it will switch itself on automatically.
–After the first battery charge and discharge you may replace your handset in the charg- ing cradle after every call.
Please remember:
uAlways repeat the charging and dis- charging procedure if you remove the battery pack from the handset and insert it again.
6