Appendix
Appendix
Care
¤Wipe the charging cradle and the hand- set with a damp cloth (do not use sol- vent) or an antistatic cloth.
Never use a dry cloth. This can cause static.
Contact with liquid !
Your handset is splash proof.
If it comes into contact with water, knock the water out of the microphone opening and remove any water on the handset with an absorbent cloth. Your handset is ready for use.
If your handset comes into contact with a larger amount of liquid take the following steps:
1.Do not switch the handset on under any circumstances!
2.Remove the battery pack immediately.
3.Remove the headset socket cover.
4.Hold the handset horizontally with the open battery compartment facing down.
5.Hold the handset vertically. Tilt the handset backwards and forwards slightly, giving it a gentle shake each time.
6.Dab all parts dry and then leave the handset for at least 72 hours with the battery compartment open and the keypad facing down in a dry, warm place (not: microwave, oven or similar).
When it has fully dried out, you will normally be able to use it again.
Questions and answers
If you have any queries about the use of your telephone, you can contact us at any time at www.siemens.com/gigasetcus- tomercare . The table below contains a list of common problems and possible solu- tions.
The display is blank.
1. The¥ handset is not switched on.
Press and hold the end call key a.
2.The¥ battery pack is flat. Charge/replace the battery pack (page 4).
The handset does not respond to a key press.
The¥ keypad lock is activated.
Press and hold the hash key # (page 8).
"Base station x" is flashing in the display.
1.The handset is outside the range of the base
station¥ .
Reduce the distance between handset/ base station.
2.The¥ handset has been
Base Search is flashing in the display.
Handset is set for Best Base and no base station is¥within range.
Reduce the distance between handset/base station.
Handset does not ring.
The¥ ringtone is switched off. Activate the ringtone (page 16).
The other party cannot hear you.
You have pressed the u(INT) key. The handset ¥ is "muted".
Switch on the microphone again (page 8).
You hear an error tone when keying an input
(a descending sequence of tones).
Action¥ has failed/invalid input. Repeat the operation.
Watch the display and refer to the operating instructions if necessary.
18