User Configuration Items

The user can configure the phone behaviour relating to a line and the corresponding overview accord- ing to his personal needs.

Line Configuration Menu

The menu can be accessed using the Web Based Management (WBM) or the local user menu at the phone. The location is:

User > Configuration > Keyset > Lines

WPI (see [4]) tags are available for these settings, too.

 

User Line Key Configuration

 

The keyset line configuration can be

 

done separately for each individual

 

line. Each line has a tab of its own in

 

which the parameters are set.

 

 

Parameter

Meaning

Ring delay

Number of seconds until the phone will play the ringing tone for an incoming call.

(seconds)

 

Allow in

If checked, the line will be shown in the overview table.

overview

 

Address

AoR resp. call number for this line (not configurable by the user).

Primary line

Line status (not configurable by the user).

Ring on/off

If checked, a ringer tone is played for incoming calls on this line (not configurable

 

by the user).

Selection order

Used for outgoing calls if idle lines are selected automatically (not configurable by

 

the user).

Hot/warm line

Not used in this context.

Hot/warm

Not used in this context.

destination

 

Multi Address Appearance on OpenStage

00.00.2007 I 15

Page 15
Image 15
Siemens MG-2D manual User Configuration Items, Line Configuration Menu, User Configuration Keyset Lines