2-8 Installation
Series
505 High Speed Counter
and Encoder Module User
’
s Manual
2.4 Wiring the Module
2.4.1
Wiring the W
iring the module consists of wiring the the input and output signals.
Ter
minal Block
See Figure 2-4 and Figure 2-5 for general guidelines. All connections are
made at the module terminal block. See Figure 2-5. Output returns for
Channel 1 and 2 are internally connected.
Use the T
erminal Block W
orksheet in Appendix B for planning your wiring.
! Tur
n of
f power to the I/O base and any modules installed in the base
befor
e inserting or removing a module. Failur
e to do so may cause
potential injury to personnel or can damage equipment.
2.4.2
Powering Up
After wiring the terminal block for the HSC, restore power to the
the Module
base.
1cm
(0.4 in.)
Wire
Gauge: 22–16
Max.
W
idth: 5.54 mm (
.
218 in.)
Stud
Size: #4 (2.5mm)
Amp Part#: 321462
Max.
W
idth: 4.62 mm (
.
182 in.)
Stud
Size: #4 (2.5mm)
Amp Part#: 327891
(Specify 2pt. connector)
Figure 2-4 W
iring Guidelines