Sierra Wireless 20070914 - page 120

Raven 1x
115 20070914
S83=n
SetorqueryUDPautoansweridletime‐out.Ifnodataissent
orreceivedbeforethetime‐outoccurs,thecurrentUDPsession
willbeterminated.Whileasessionisactive,packetsfrom
otherIPaddresseswillbediscarded(unless*UALLisset).
•n=0:Noidletime‐out(Default).
•n=1‐255:Time‐outinseconds.
*DU=n
ThedialcommandalwaysusesUDP,evenwhenusingATDT.
•n=0:Dialusingthemeansspecified(default).
•n=1:DialUDPalways,evenwhenusingATDT.
Note: When this parameter is set you cannot establish a TCP PAD
connection.
*UALL=n
AcceptsUDPpacketsfromanyIPaddresswhenaUDP
sessionisactive.IfthereisnoUDPsessionactive,anincoming
UDPpacketwillbetreatedaccordingtotheUDPautoanswer
andAIPsettings.
•n=0:Noeffect(Default).
•n=1:AcceptUDPdatafromallIPaddresseswhenina
UDPsession.
*UDPLAST=n
Note: *UDPLAST does not
change the S53 setting in
NVRAM. If the modem is reset,
the original S53 setting will be
restored from NVRAM.
Ifenabled,setsS53tothelastacceptedIPaddressthrough
UDPautoanswer.ThiscanbeusedinconjunctionwithMD3
sothatwhenthereisnoUDPsession,newethernethostdata
willcauseaconnectiontoberestoredtothelastIPaccepted
throughUDPautoanswer.
•n=0:DoesnotchangeS53setting.(Default).
•n=1:SetS53tothelastacceptedIP.
*USD=n
Wait sthespecifieddelaybeforesendingthefirstUDPpacket
andthesubsequentUDPpacketsouttotheportEthernet.
•n=0:NoUDPpacketdelay(Default).
•n=1‐255:Delayin100msunits,from100msto25.5sec.