Hardware Installation of the Raven XE
Figure 4-4: USB
Your Raven XE’s full‐speed (12 Mbit) USB 2.0 port can be connected directly to most computers or other devices using a standard full‐speed USB 2.0 cable. If the computer or device you are connecting or the cable is not rated for full‐speed, the modem will communicate at a reduced speed to match. The Raven XE functions as a device, not a host.
When it is connected to a computer, the USB port should be seen as a COM port or Ethernet port after the applicable driver is installed.
The Raven XE has a standard mini‐B connector.
Warning: The USB port can only be used in a non- hazardous environment.
Indicator Lights
When your Raven XE is connected to power and an antenna, there is a specific pattern to the lights to indicate its operation mode.
Figure 4-5: Raven XE Indicator lights
•Network ‐ Indicates a successful connection to the cellular network with an IP address given and a channel acquired.
•Signal ‐ Light shows the strength of the signal and may be nearly solid (strong signal) or flashing (weaker signal). A slow flash indicates a very weak signal.
|
|
|
|
|
|
|
Rev 1.0 Oct.09 |
|
|
|
|
| 21 |
|
|
|
