Thunder storms!
Devices connected to mains power can be damaged during a thunder storm. If there is a thunder storm, always remove the mains plug from the socket.
•If the appliance is not going to be used for long periods, remove the batteries.
•If batteries leak, put on protective gloves.
•Clean the battery compartment and contacts with a dry cloth.
Information on voltage surges (EFT/electrical fast transient) and electrostatic discharges:
If the product does not work properly due to elec- trical fast transient processes (voltage surges) or electrostatic discharge, it must be reset to restore normal operation. If necessary, remove the plug from the power socket and insert it again. The batteries (if used) must be removed and reinserted.
Information on separating the device from mains power
The POWER button on this device does not completely separate it from the mains network. In addition, the device uses power when in standby mode. In order to completely separate the device from the mains supply the plug must be removed from the mains socket.
Notes on handling batteries
The device uses batteries. Please note the following on handling batteries:
Risk of explosion!
Do not throw batteries into a fire.
Do not recharge batteries.
•Never open, solder or weld batteries. There is a risk of explosion and injury!
•Check batteries regularly. Leaking batteries can damage the device.
Caution!
No liability/warranty applies to damage to the device caused by moisture due to water penetrating the device or overheating!
Operating elements
Front side
1Memory buttons
2 Screen
3 Button SNOOZE
4 Frequency selection switch
5 Button PAGE
6 Button FINE
7 Button POWER
8 Buttons UP/DOWN
9 Buttons VOL.+ (AL–1)/VOL.– (AL–2)
0 Button MODE q Button BASS
w Button MEMORY SCAN e Button MEM
r Speakers
Back
tStand z Aerial
u Carrying strap i Switch SW SEN.
o Headphone output
p DC INPUT 7.5 V: Adapter slot
- 4 -
