General functions
Key lock
In order to prevent changing the settings unintention- ally by touching the buttons, you can activate the key lock.
•Press and hold down the MEM button for around
3 seconds. The screen will flash 
. All but- tons except the SNOOZE button are now locked.
•Press and hold down the MEM button again for about 3 seconds to cancel the key lock. The 
message on the screen disappears.
Screen lighting
•Press any button to illuminate the screen.
The screen will remain lit for about 10 seconds.
Stand
•Flip out the stand on the rear of the device to enable it to stand more stably.
Time functions
The time functions can only be set when the radio is switched off. If the time cannot be set using the RDS signal, the default time of the world receiver starts at 0:00 00.
The settings are lost if the device is disconnected from its power supply.
Time, date, time zone and world time
You can use the MODE button to set the time, date and time zone, query the world time and set the date alarm, medium wave reception, alarm time reception, hourly mode and time update.
When you press MODE, the function to be set flashes for about 15 seconds. During this time, adjust the setting with the UP/DOWN buttons.
•Press MODE x 1: Set clock time.
•Press MODE x 2: Set the date.
•Press MODE x 3: Set time zone („Local city”).
•Press MODE x 4: Show world time.
•Press MODE x 5: Date alarm.
•Press MODE x 6: Set reception range for medium wave.
•Press MODE x 7: Set alarm pause.
•Press MODE x 8: Set 12/24 hour mode.
•Press MODE x 9: Set automatic time query.
To apply a setting, just wait until the screen stops flashing (the screen reverts to the time indication) or press MODE to move on to the next function.
Setting clock time
•Press MODE once. The most recently set time flashes on the screen.
•Press the UP or DOWN button to move the time forward or backward at minute intervals. Hold down one of the buttons for a few seconds to move the setting forward or backward quickly at 10 minute intervals.
Note:
Set the time without summer time offset. If summer time is required, this can be set when setting the time zone (see below).
- 6 -
