Setting up and connecting

GB

IE

Disassembly

♦Press both unlocking buttons 20 on the rear panel of the device downwards, thereby sliding, at the same time, the device forward and then remove the device downwards.

♦Unscrew the screws on the mounting plate and remove the mounting plate .

Setting up the device

As an alternative you can stand the device on a top. So as not to cover up the ventilation slots and the speaker 18 on the underside of the device, when setting up the device it must be mounted on the stand . For assembly of the stand proceed as follows:

♦Press both unlocking buttons 20 on the rear panel of the device downwards

thereby, at the same time, sliding the mounting plate backwards and remove the mounting plate . The mounting plate can now be used as a stand.

♦Slide both front retaining tabs of the stand into the rear recesses 17 on the underside of the device.

♦Press both rear retaining tabs of the stand into the front recesses 17 on the underside of the device until the stand audibly locks into place.

♦Find a suitable set-up location for the device (see also the section Requirements for the set-up location).

Providing mains power

♦Insert the mains connection cable 16 power plug into a socket. The time of day will be shown in the display 3 (0:00 o'clock).

VHF wire antenna

♦Unwind the wire antenna 15 completely for VHF reception.

10

SKRD 30 A1