Silvercrest SKRD 30 A1 Radio operation, Switching the radio on/oﬀ, Adjusting the volume, Manual station selection, Search for the next station

Handling and operation

Radio operation

NOTICE

►For a good radio reception the wire antenna 15 must be completely un- coiled. Adjust the antenna, whilst in radio operation, to the best reception.

►The technical factors of the device allow for tuning reception frequencies outside of the permitted VHF (FM) range of 87.5–108 MHz. In some countries, diﬀerent national regulations may apply to the assigned radio frequency ranges.

Please note that information received outside of the assigned radio frequency ranges may not be exploited, passed on to third parties or otherwise misused.

Switching the radio on/oﬀ

♦Switch the radio on by pressing the On/Oﬀ 4 button.The display 3 shows the current reception frequency of the tuned station.

♦Switch the radio oﬀ by pressing the On/Oﬀ 4 button again.The device changes back to the operational mode clock/standby operation. The cur- rent time of day is shown.

Adjusting the volume.

♦With the VOLUME 14 knob set the desired volume. Turning in a clockwise direction increases the volume; turning in a counter clockwise direction reduces the volume. The volume level is shown on the left border of the display 3 .

Manual station selection

♦By a single press on the buttons Tune+ 13 and Tune– 12 tune the desired station. The frequency of the station is shown in the display 3 . During the tuning the speaker is switched oﬀ.

Search for the next station

The device can automatically search for the nearest station.

♦Press and hold down the button Tune+ 13 or Tune- 12 for at least two seconds. The device searches for the nearest station with suﬃcient reception quality.

♦Repeat this process until you have found the station you are looking for.

SKRD 30 A1