Setting up and connecting

Inserting the battery

By inserting the battery you can avoid the loss of programmed time of day and alarm times in the event of a possible power outage. The battery ensures that the internal clock continues to run even during a power failure. When power is restored the correct time appears automatically in the display 3 .

NOTICE

►The device can also be operated without a battery.

♦Open the cover of the battery compartment 19 on the underside of the device by turning the cover to the left, with a coin, as far as it will go and then lift off.

♦Insert the battery type CR2032 (supplied) into the battery compartment. The side with the marking + points upwards.

♦Close the battery compartment by attaching the cover and then with a coin turn it to the right.

Mounting under a wall cupboard

(Illustration see fold out side figure B)

With the supplied mounting plate you can mount the device under, for exam- ple, a wall cupboard. For mounting of the device proceed as follows:

♦Press both unlocking buttons 20 on the rear panel of the device downwards

thereby, at the same time, sliding the mounting plate backwards and remove the mounting plate .

♦Find a suitable set-up location for the device (see also the section Requirements for the set-up location).

♦Hold the mounting plate under the set-up location. Thereby the front

edge of the mounting plate should be approx. 4 cm behind the front of the cupboard so that, after Remove the mounting, the device is flush with the cupboard.

♦Mark the 4 fastening points with a pencil.

♦Using a spike or nail, make a small depression at the respective marking

points. Screw the mounting plate tightly with the supplied screws as illustrated in figure B.

♦Place the device aslant, with the front recesses in the top face, in the mount-

ing plate . Press the rear part of the device upwards against the mounting

plate until the device audibly locks into place.

♦Check to make sure that the device is secure.

GB

IE

SKRD 30 A1

9