•Changing the fuses.
Before changing the fuse disconnect the unit from the mains power supply.
The fuse compartment is next to the power supply con- nector (Fig. 3). Remove the fuse holder (2) with a flat head screwdriver and replace the fuse (3). Fit a new spare fuse
(4). Use only T 3,15 A H fuses.
• Do not allow the unit to overheat. |
To prevent this, allow a free space of at least 40 cm around |
the back of the projector. |
Do not block the ventilation slots. |
Do not place the unit near to heat sources such as ovens, |
radiators or other devices (including amplifiers). |
Do not place the unit in a restricted area (shelving units, |
bookshelves, etc.) and in general avoid placing it in poorly |
ventilated areas as this can lead to overheating. |
pas | compromettre | ||||
|
| d'incende | |||
resque |
| type | |||
le de | meme |
| |||
ique |
|
| against | ||
d protection | |||||
| |||||
1
A
OUT
2
4 | 250 V |
| |
| T 3.15A H |
3
Fig.3
• Never look directly at the projection lamp. |
Never look directly into the lamp when it is on as the inten- |
se light can damage your eyes. Take particular care that |
children cannot do so. |
• Take special care regarding the movements of the |
lens. |
Do not place objects in the slots on the side of the lens, |
and also ensure that the lens’s horizontal and vertical mo- |
vements are unimpeded by external objects. |
• Position the unit on a stable surface. |
•Be careful with cables.
Make certain cables are routed so that people will not be impeded or tripped up.
Keep all cables away from children.
Install the unit as close to the wall socket as possible. Avoid stepping on power cables, make certain they do not be- come tangled, and never jerk or tug them; do not expose them to sources of heat, and make sure they do are not knotted or crimped. If the power cables become dama- ged, stop using the system and request the assistance of an authorised technician.
•Disconnect the unit from the mains power supply in the event of electrical storms and when not in use.
To prevent damage from lightning strikes in the vicinity, disconnect the unit during storms or when the sytsem is going to be left unused for a long time.
•Avoid contact with liquids and exposure to damp.
Do not use the unit near to water (sinks, tubs, etc.); do not place objects containing liquids on or near to the unit and do not expose it to rain, humidity, drops of water or sprays; do not use water or liquid detergent to clean it.
Place the projector on a stable surface or use the provided |
ceiling mounting bracket. |
Never place the projector on its side or rear, lens or top |
panel. |
• Do not insert objects through the openings in the unit. |
Make sure that no objects are inserted inside the units. If this |
should occur, disconnect the unit from the power supply |
immediately and call an authorised technician. |
• Energy savings. |
Disconnect the power supply when the projector is not |
in use. This will considerably reduce power consumption |
and also lengthen the service life of the unit’s electrical |
circuitry. |
