PROC3
12 TROUBLESHOOTING GUIDE
No power (LEDs always OFF)
•Check that the units’ power switches are set to I.
•Check that the power cables are correctly connected to the units’ power sockets.
•Check the condition of the fuse located on the power socket on the rear of the projector.
•Replace the fuse located on the projector’s power socket with an identical type (T 3,15A H).
•If the fuse blows repeatedly, seek technical assistance from your nearest Dealer.
Lamp fails to switch on
•If this happens immediately after the last time the unit was switched off, allow a few minutes between switching off and switching on again. This will allow the lamp to cool down sufficiently.
•If the lamp fails to illuminate - even though the unit has had time to cool down - seek technical assistance from your nearest Dealer.
•Check the state of the connection by interpreting the code displayed by the system LEDs in accordance with Table 1.
No image
•Make sure the selected input is connected to a video or graphic signal and that that source is functioning cor- rectly.
•Make sure the video or graphic signals supplied by the source are compatible with the
•Check the condition of the cables used to connect the projector to its input sources. • Check the state of the con- nection by interpreting the code displayed by the system LEDs.
•Make sure the cooling air vents on the units are not blocked and that the ambient temperature is below 35°C.
Image is disturbed, unstable or noisy
•Check compatibility of the video or graphic signals with the technical specifications of the system, and specifically, with the specifications of the selected input.
•Check all cables.
•If the problem occurs on a terrestrial broadcast source signal, check that the receiver has been correctly tuned in and that the aerial system is in good working order.
•If the problem occurs in a video signal from a videorecor- der, ensure that the videotape is in good condition and that VCR mode is active in the PICTURE menu.
•Adjust the Sharpness parameter in the PICTURE menu to optimise the projected image.
Incomplete image along borders (vertical and horizontal)
•Check compatibility of the video or graphic signals with the technical specifications of the system, and specifically, with the specifications of the selected input.
•Recall the automatic image adjustment function by pres- sing the key “A” on the remote control or ◀ on the projector’s keypad.
•Adjust the horizontal and vertical position of the image with the IMAGE / POSITION menu (if available for the input in question).
•Adjust the width and height of the image, selecting Aspect in the IMAGE ADJUSTMENTS / ASPECT menu.
•Adjust the overscan value applied to the image on the IMAGE / OVERSCAN menu.
Image too dark, too pale or unnaturally coloured
•Check compatibility of the video or graphic signals with the technical specifications of the system, and specifically, with the specifications of the selected input.
•Adjust the Contrast, Brightness, Colour and Tint parameters in the PICTURE menu.
•If necessary, adjust Color Temperature and Gamma Correction (IMAGE menu).
27
