Operation
4.On hydro model, release the parking brake by depressing the brake pedal (A, figure Et), then press down on either pedal (I or J, figure 2) for the desired direction and speed of travel.
On gear model, fully depress clutch/brake pedal (A, figure 8) to release the parking brake and disengage the clutch. Use the gear selector (I, figure 3) to select the gear best suited for conditions, then slowly release clutch/brake pedal to engage clutch and start tractor in motion.
STOPPING THE TRACTOR
1.On hydro model, gradually take your foot off the ped- als (I & J, figure 2) to make a smooth stop. To make a more rapid stop, depress the brake pedal (H, figure 2).
On gear model, press the clutch/brake pedal (A, fig- ure 8) down only far enough to disengage the clutch to make a gradual stop. For a more rapid stop, press pedal down fully to apply the brake.
2.Engage the parking brake by pulling up on the knob (B, figure 8) with the brake pedal fully depressed.
3.Disengage the PTO by pushing down on the switch (F, figures 2 & 3).
4.Set engine throttle control to SLOW. Stopping a hot engine too fast may cause engine damage. Let engine idle for about a minute.
5.Turn key to OFF and remove it.
Before leaving the operator’s position for any reason, engage the parking brake, disengage the PTO, stop the engine and remove the key .
A WARNING
To reduce fire hazard, keep the engine, tractor and mower free of grass, leaves and excess grease. Do not stop or park tractor over dry leaves, grass or combustible materials .
‘.
PUSHING THE TRACTOR-BY HAND
Hydro Model
1.With engine off and key removed, disengage the PTO by pushing the switch (F, figures 2 8 3) all the way down.
2.See figure 9. The release lever is located under the rear tractor frame, above the transmission. Release lever must be in the rearward position to push the tractor by hand.
To drive the tractor, release lever must be moved completely forward to engage the DRIVE position.
Gear Model
1.With engine off and key removed, disengage the PTO by pushing the switch (F, figures 2 & 3) all the way down.
2.Place the gear selector in the NEUTRAL position.
3.Unlock parking brake.
|
|
|
|
I | I I | , | 1 |
| |||
|
|
|
|
Figure 9 . Release Lever - Hydro Models
1 0
