Trim Installation
Face | Mask | installation: |
| |
1 . Position the face mask onto |
| |||
the unit with the hook in the |
| |||
middle grille slot, and line |
| |||
up with the holes on the |
| |||
outside of the side panels |
| |||
(note that the front of the |
| |||
face mask must be in the |
| |||
“V” position for proper fit.) |
| |||
2. Insert one Carriage Bolt | Hook from Face | |||
Mask goes into | ||||
through each | of the two | |||
middle gri//e s/o’\ | ||||
mounting holes at the rear |
| |||
of the face mask, and into |
| |||
the | side panels. |
| ||
3.Place one washer onto each Carriage Bolt from the inside of the panel.
4.Thread one Nut onto each Carriage Bolt.
5.Check that the Face Mask is in the proper position and
orientation. | NOTE: “V” positioning | ||
6. Tighten the Nuts securely. |
| Carriage1 Bolt | b |
