HP B160L, B132L, B180L manual Installing a Hard Disk Drive in Position 1 Rear Position

Changing Your Workstation’s Hardware Configuration

Installing Storage Devices

Installing a Hard Disk Drive in Position 1 (Rear Position)

Perform the following procedure to install a hard disk drive in position 1:

1Align the four feet on the bottom of the drive carrier with the square holes in the storage tray, as shown in Figure 38.

Figure 38 Installing a Hard Disk Drive in Position 1 (Rear Position)

2Set the drive in the storage tray.

3Connect the power connector and the appropriate SCSI connector to the drive.

4Push the drive toward the rear of the tray until the locking tab on the drive carrier snaps into place, as shown in Figure 38.

5Proceed to the section entitled Replacing the Storage Tray Cover on page 132.

131