HP B160L, B132L, B180L manual Installing Memory Modules

Changing Your Workstation’s Hardware Configuration

Installing Additional memory

3Close the ejector tabs on each side of the memory connector to lessen the force required to seat the memory module, as shown in Figure 47.

4Line up the memory module with the guides making sure that the notched end of the memory module is toward the white ejector tab (front of the main tray), as shown in Figure 47.

White Ejector Tab

Figure 47 Installing Memory Modules

5Press firmly and evenly on the memory module to ensure that it is fully seated.

6Install the memory retainer.

7To verify that this installation was successful, follow the steps in Appendix D, “The Boot Console Interface,” on displaying memory information. If you have only replaced a faulty memory module, you must issue the pdt clear command in the service menu of the Boot Console Interface. Answer yes (y) to the prompt “ Continue? (Y/N) >.”

143